Inspection
Low & Reverse BrakeLOW & REVERSE BRAKE:
Clutches and Brakes / LOW & REVERSE BRAKE:
INSPECTION
Low and Reverse Brake Snap Ring and Spring Retainer
Check for deformation, or damage.
Low and Reverse Brake Return Springs
Check for deformation or damage. Also measure free length and outside diameter.
Low and Reverse Brake Drive Plates
Check facing for burns, cracks or damage.
Measure thickness of facing.
Thickness of drive plate:
Standard value.......................1.52 -1.67 mm (0.0598 - 0.0657 inch)
Wear limit............................40 mm (0.0551 inch)
If not within wear limit, replace.
Low One-way Clutch Inner Race
Check frictional surface of inner race for wear or damage.
Install a new seal rings onto low one-way clutch inner race.
Be careful not to expand seal ring gap excessively.
Measure seal ring-to-groove clearance.
Inspection standard:
Standard value:......................0.10 - 0.25 mm (0.0039 - 0.0098 inch)
Allowable limit:...........................0.25 mm (0.0098 inch)
If not within allowable limit, replace low one-way clutch inner race.