Disassembly

Reverse Clutch

Reverse Clutch:

DISASSEMBLY
1. Check operation of reverse clutch.





a. Install seal ring onto oil pump cover and install reverse clutch. Apply compressed air to oil hole.
b. Check to see that retaining plate moves to snap ring.
c. If retaining plate does not contact snap ring,
- O-ring might be damaged.
- Oil seal might be damaged.
- Fluid might be leaking past piston check ball.





2. Remove drive plates, driven plates, retaining plate, dish plate and snap ring.





3. Remove snap ring from clutch drum while compressing clutch springs.
Do not expand snap ring excessively.

4. Remove spring retainer and return spring.





5. Install seal ring onto oil pump cover and install reverse clutch drum. While holding piston, gradually apply compressed air to oil hole until piston is removed.
Do not apply compressed air abruptly.

6. Remove D-ring and oil seal from piston.