Radiator: Service and Repair

Components

Removal and Installation
1. Remove undercover.
2. Drain coolant from radiator drain plug. .
3. Remove air duct (from mass air flow sensor to throttle body).
4. Disconnect radiator upper and lower hoses.
5. Remove A/T oil cooler hoses, if equipped.
6. Remove radiator lower shroud.
7. Disconnect reservoir tank hose.
8. Remove the radiator.
9. After repairing or replacing the radiator as necessary, installation is in the reverse order of removal.
10. Refill the engine cooling system.
^ After installation, run the engine until it reaches operating temperature and check the system for leaks.

Inspection





1. Apply pressure with Tool.
Specified test pressure 157 kPa (1.6 kg/cm2, 23 psi)





2. Check radiator for leaks in water tank by looking for bubbles.