Programming and Relearning

ID REGISTRATION WITH TRANSMITTER ACTIVATION TOOL
1. Turn ignition switch "OFF".
2. Connect CONSULT-II to data link connector.
3. Start engine.
4. Touch "START", "AIR PRESSURE MONITOR", "WORK SUPPORT" and "ID REGIST".
5. Touch "START" on the CONSULT-II.





6. With the transmitter activation tool (J-45295) pushed against the front-left transmitter, press the button. The LED illuminates for approximately 5 seconds.





7. Register the IDs in order from FR LH, FR RH, RR RH, to RR LH. When ID registration of each wheel has been completed, a chime sounds and hazard warning lamp blinks.
8. After completing all ID registrations, press "END" to complete the procedure.

NOTE: Be sure to register the IDs in the designated order or the self-diagnostic results display will not function properly.

ID REGISTRATION WITHOUT TRANSMITTER ACTIVATION TOOL
1. Turn ignition switch "OFF".
2. Connect CONSULT-II to data link connector.
3. Start engine.
4. Touch "START", "AIR PRESSURE MONITOR", "WORK" SUPPORT" and "ID REGIST".
5. Touch "START" on the CONSULT-II.






6. Adjust the tire pressure to the values shown in the table for ID registration, and drive the vehicle at 32 km/h (20 MPH) or more for a few minutes.






7. When ID registration of each wheel has been completed, a chime sounds and hazard warning lamp blinks.
8. After completing all ID registrations, press "END" to complete the procedure.