ABS/VDC/TCS

ABS Actuator and Electric Unit

ABS/VDC/TCS ACTUATOR AND ELECTRIC UNIT:

REMOVAL
1. Disconnect battery cable.
2. Disconnect connector and brake pipes.
3. Remove fixing bolts.

INSTALLATION

CAUTION: After installation, refill brake fluid. Then bleed air.

1. Connect brake pipes temporarily.
2. Tighten fixing bolts.
3. Tighten brake pipes.

Tightening torque:.........................16.7 - 21.6 Nm (1.7 - 2.2 kgf-cm, 13 -15 ft. lbs.)

4. Connect connector and battery cable.
5. Adjust steering angle sensor neutral position.
Steering Angle Sensor