Diagnostic Procedure 3

DIAGNOSTIC PROCEDURE 3 / With CONSULT-II Scan Tool

Final checking after repairing SRS by using CONSULT-II -Diagnosis mode






1. After repairing SRS, connect both battery cables.
2. Connect CONSULT-II to data link connector.
3. Turn ignition switch ON.






4. Touch "START".






5. Touch "AIR BAG".






6. Touch "SELF-DIAG [CURRENT]".






7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Refer to step 8.

If any malfunction was detected on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Refer to "DIAGNOSTIC PROCEDURE 2" and repair malfunctioning part completely.
Diagnostic Procedure 2






8. Touch "ERASE".

NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").

If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the "AIR BAG" warning lamp even if the malfunction is repaired completely.






9. Touch "BACK" key of CONSULT-II to "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".






10. Check that no malfunction is detected on "SELF-DIAG [PAST]".

11. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.

12. Turn ignition switch OFF, then turn off and disconnect CONSULT-II.

13. Go to "SRS Operation Check" to check SRS operation by using "AIR BAG" warning lamp with User mode.
[1][2]Component Tests and General Diagnostics