Auto-Lock Free-Running Hub

AUTO-LOCK FREE-RUNNING HUB





2WD





4WD models

Removal and Installation





1. Remove auto-lock free-running hub assembly.





2. Remove snap ring.





3. Remove spindle washer and fixed cam assembly.
4. Install fixed cam assembly. Be sure to align the tabs of the fixed cam assembly to the notches of the knuckle.

CAUTION: During installation, apply recommended grease to the parts.

5. Place the spindle washer and then the snap ring over the axle shaft positioning them between the two locking grooves.
6. While supporting the axle shaft behind the knuckle, use an appropriate sized deep socket to securely seat the snap ring into the inner locking Groove.

CAUTION: Visually verify that the snap ring is fully seated into the locking groove.

7. After installing auto-lock free-running hub, check operation.