Removal And Installation

INSTRUMENT PANEL ASSEMBLY

Part 1:

Part 2:

Removal and Installation
1. Remove the center console. Refer to "CENTER CONSOLE".
2. Remove the steering column. Refer to "STEERING COLUMN".
3. Remove the combination meter. Refer to "COMBINATION METER".
4. Release then disconnect the optical sensor harness.
5. Remove the LH and RH windshield garnish.
6. Remove instrument panel.
- Disconnect harnesses to instrument panel speakers LH and RH and remove speakers.
- Disconnect all remaining harnesses.
- Remove the passenger air bag module. Refer to "FRONT PASSENGER AIR BAG MODULE".

Installation
Installation is in the reverse order of removal.

CLUSTER LID C

Removal
1. Remove cluster lid D. Refer to "CLUSTER LID D".
2. Remove storage tray and storage tray liner, then remove cluster lid C screw.
3. Pull cluster lid C rearward to release clips.
4. Disconnect electrical connectors and remove cluster lid C.

Installation
Installation is in the reverse order of removal.

CLUSTER LID D

Removal
1. Remove center console. Refer to "CENTER CONSOLE".
2. Remove lower instrument panel LH. Refer to "LOWER INSTRUMENT PANEL LH".
3. Remove glove box lower. Refer to "LOWER INSTRUMENT PANEL RH AND GLOVE BOX".
4. Disconnect the electrical connectors and remove cluster lid D.

Installation
Installation is in the reverse order of removal.

LOWER INSTRUMENT PANEL LH

Removal
1. Remove lower dash side finisher. Refer to "Removal".
2. Remove front pillar finisher. Refer to "Removal".




3. Remove screws using power tool, and remove lower instrument panel LH.
4. Pull rearward to release clips, disconnect connectors, and remove lower instrument panel LH.

Installation
Installation is in the reverse order of removal.

COMBINATION METER

Removal
1. Disconnect the negative battery cable.
2. Remove the lower instrument panel LH. Refer to "LOWER INSTRUMENT PANEL LH".
3. Remove cluster lid A.




4. Remove screws using power tool and remove the combination meter assembly.
- Disconnect electrical connectors.

Installation
Installation is in the reverse order of removal.

A/T FINISHER
1. Remove cup holder finisher.
2. Remove A/T finisher bezel.




3. Pull up to release clips and remove the A/T finisher.

Installation
Installation is in the reverse order of removal.

M/T FINISHER
1. Remove cup holder finisher.
2. Remove M/T finisher bezel.




3. Pull up to release clips and remove the M/T finisher.

Installation
Installation is in the reverse order of removal.

LOWER INSTRUMENT PANEL RH AND GLOVE BOX

Removal - lower glove box
1. Remove lower glove box lower screws.
2. Remove lower dash side finisher. Refer to "Removal".
3. Remove lower front pillar finisher. Refer to "Removal".
4. Remove lower glove box side screw.
5. Using power tool, remove screws and glove box lower latch cover.
6. Remove lower glove box upper screws, then remove lower instrument panel RH and glove box (lower) as an assembly.

Installation - lower glove box
Installation is in the reverse order of removal.

NOTE: Upper glove box assembly must be installed prior to lower glove box assembly.

Removal - upper glove box
1. Remove lower glove box assembly. Refer to "LOWER INSTRUMENT PANEL RH AND GLOVE BOX".
2. Remove screws and upper glove box assembly.

Installation - upper glove box
Installation is in the reverse order of removal.




CENTER CONSOLE
1. Remove cup holder finisher.
2. Remove A/T or M/T finisher. Refer to "A/T FINISHER".
3. Remove center console screws.
4. Disconnect electrical connectors and remove center console.

Installation
Installation is in the reverse order of removal.