CONSULT-II Checking System

CONSULT-II CHECKING SYSTEM

Description
- CONSULT-II is a hand-held type tester. When it is connected with a diagnostic connector equipped on the vehicle side, it will communicate with the control unit equipped in the vehicle and then enable various kinds of diagnostic tests.
- Refer to "CONSULT Operator's Manual" for more information.

Function And System Application:

Function and System Application

Nickel Metal Hydride Battery Replacement
CONSULT-II contains a nickel metal hydride battery. When replacing the battery obey the following:

WARNING:
Replace the nickel metal hydride battery with Genuine CONSULT-II battery only. Use of another battery may present a risk of fire or explosion. The battery may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble or dispose of in fire.
Keep the battery out of reach of children and discard used battery conforming to the local regulations.




Checking Equipment
When ordering the below equipment, contact your NISSAN distributor.

CONSULT-II Start Procedure




1. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.




2. If necessary turn on the ignition switch.
3. Touch "START (NISSAN BASED VECL)" or "System Shortcut" (eg: Engine) on the screen.

CONSULT-II Data Link Connector (DLC) Circuit:

CONSULT-II Data Link Connector (DLC) Circuit




INSPECTION PROCEDURE
If the CONSULT-II cannot diagnose the system properly, check the following items.