Timing Components: Specifications

Timing Chain Tensioner
Timing chain tensioner (secondary) (left bank) 8.5 Nm (0.87 kg-m, 75 inch lbs.)
Timing chain tensioner (primary) 8.1 Nm (0.83 kg-m, 72 inch lbs.)
Tension guide 21.6 Nm (2.2 kg-cm, 16 ft. lbs.)
Timing chain tensioner (secondary) (right bank) 8.5 Nm (0.87 kg-cm, 75 inch lbs.)

Crankshaft Pulley
Install crankshaft pulley as follows:
Install crankshaft pulley, taking care not to damage front oil seal.
When press-fitting crankshaft pulley with plastic hammer, tap on its center portion (not circumference).
Tighten crankshaft pulley bolt.
Crankshaft bolt torque 44.1 Nm (4.5 kg-m, 33 ft. lbs.)





Put a paint mark on crankshaft pulley aligning with angle mark on crankshaft pulley bolt. Then, further retighten bolt by 60° (equivalent to one graduation).
Rotate crankshaft pulley in normal direction (clockwise when viewed from front) to confirm it turns smoothly.

Timing Cover
Chain Tensioner Cover 11.3 Nm (1.2 kg-m, 8 ft. lbs.)