Body Control Module: Service and Repair
Removal and Installation of BCMREMOVAL
NOTE: If possible, before removing BCM, retrieve current BCM configuration to use for reference when configuring brand-new BCM after installation. Refer to "Configuration".
1. Disconnect negative battery cable.
2. Remove lower knee protector. Refer to "LOWER INSTRUMENT PANEL LH".
3. Remove screws and release BCM.
4. Disconnect connectors and then remove BCM.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
- When replacing BCM, it must be configured. Refer to "Configuration".
- When replacing BCM, perform initialization of NATS system and registration of all NATS ignition key IDs. Refer to BL-123, "NVIS(NISSAN Vehicle Immobilizer System-NATS)". Antitheft and Alarm Systems
- When replacing BCM, perform ID registration procedure of low tire pressure warning system. Refer to WT-12, "ID Registration Procedure". Tire Pressure Sensor Reset Procedure
- After disconnecting/reconnecting negative battery cable, adjust neutral position of steering angle sensor before running vehicle (with VDC). Refer to "Adjustment of Steering Angle Sensor Neutral Position".