Precautions For Transfer Assembly and Transfer Control Unit Replacement

Precautions for Transfer Assembly and Transfer Control Unit Replacement
When replacing transfer assembly or transfer control unit, check the 4WD shift indicator pattern and adjustment of the position between transfer assembly and transfer control unit if necessary.

CHECK 4WD SHIFT INDICATOR PATTERN
1. Set 4WD shift switch to "2WD", "4H", "4LO", "4H" and "2WD" in order. Stay at each switch position for at least 2 seconds.





2. Confirm 4WD shift indicator lamp and 4LO indicator lamp are changed properly as follows.
^ If OK, the position between transfer assembly and transfer control unit is correct.
^ If NG, the position is different between transfer assembly and transfer control unit.
Adjust the position between transfer assembly and transfer control unit. Refer to pattern table.





Transfer position adjustment pattern

NOTE: Method of adjustment can be chosen voluntarily, according to location of 4WD shift switch.