Transfer Control Unit

Removal and Installation
REMOVAL
1. Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
2. Turn the ignition switch OFF and disconnect negative battery terminal.
3. Remove the lower instrument panel LH. Refer to "LOWER INSTRUMENT PANEL LH".





4. Disconnect the two transfer control unit connectors.
5. Remove the transfer control unit bolts.
6. Remove the transfer control unit.

INSTALLATION
Installation is in the reverse order of removal. When installing the transfer control unit, tighten bolts to the specified torque.
Transfer control unit bolts: 3.4 Nm (0.35 kg-m, 30 inch lbs.)
^ After the installation, check 4WD shift indicator pattern. If NG adjust position between transfer assembly and transfer control unit. Refer to "Precautions for Transfer Assembly and Transfer Control Unit Replacement".