G Sensor

Removal and Installation
REMOVAL
1. Remove center console. Refer to CENTER CONSOLE.





2. Remove yaw rate/side/decal G sensor attaching nuts as shown.
^ The location of the sensor is the same for all models.

CAUTION:
^ Do not use power tools to remove or install yaw rate/side/decel G sensor.
^ Do not drop or strike the yaw rate/side/decal G sensor.

3. Disconnect harness connector and remove the yaw rate/side/decel G sensor.

INSTALLATION
Installation is in the reverse order of removal.

NOTE: After performing the above work, calibrate the yaw rate/side/decal G sensor. Refer to BRC-150, Calibration of Yaw Rate/Side/Decel G Sensor. On-Vehicle Service