Oil Pan, Engine

Oil Pan
(LOWER)





Apply a continuous bead of liquid gasket using Tool to the oil pan (lower) as shown.
Tool number : WS39930000 (-)
Use Genuine RTV Silicone Sealant or equivalent. Refer to Recommended Chemical Products and Sealants.

CAUTION: Attaching should be done within 5 minutes after coating.





Install oil pan (lower).
Tighten bolts in numerical order as shown.

(UPPER)





Apply a continuous bead of liquid gasket using Tool to the lower cylinder block mating surfaces of oil pan (upper) to a limited portion as shown.
Tool number : WS39930000 (-)
Use Genuine RTV Silicone Sealant or equivalent. Refer to Recommended Chemical Products and Sealants.

CAUTION:
For bolt holes with [triangle] mark, apply liquid gasket outside the hole.
Apply a bead of 4.5 to 5.5 mm (0.177 to 0.217 inch) in diameter to area A.
Attaching should be done within 5 minutes after coating.

Install oil pan (upper).

CAUTION: Install avoiding misalignment of both oil pan gaskets and O-rings.





Tighten bolts in numerical order as shown.
There are two types of bolts. Refer to the following for locating bolts.
M8 x 100 mm (3.97 inch) 7, 11, 12, 13
M8 x 25 mm (0.98 inch) Except the above
Tighten transmission joint bolts. Refer to REMOVAL (FS5R30A), REMOVAL (FS6R31A) (4X2), REMOVAL (FS6R31A) (4X4), REMOVAL (A/T) (4X2), REMOVAL (A/T) (4X4).

Oil Pan Torque





Install two bolts in front of oil pan (upper) in numerical order as shown.
Front oil pan bolt torque 22.0 Nm (2.2 kg-m, 16 ft. lbs.)