Differential Lock Position Switch

Differential Lock Position Switch





CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE

DIFFERENTIAL CONTROL UNIT TERMINALS AND REFERENCE VALUE





CAUTION: When using a circuit tester to measure voltage for inspection, be sure not to extend forcibly any connector terminals.

DIAGNOSTIC PROCEDURE
1. CHECK DIFFERENTIAL LOCK POSITION SWITCH SIGNAL

With CONSULT-II
1. Start engine.
2. Select "DATA MONITOR" mode for "DIFF LOCK" with CONSULT-II.








3. Read out ON/OFF switching action of "D-LOCK POS SW SIG".

Without CONSULT-II
1. Start engine.








2. Check voltage between differential lock control unit harness connector terminal and ground.
OK or NG
OK >> GO TO 5.
NG >> GO TO 2.

2. CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect differential lock position switch harness connector.





3. Check continuity between differential lock position switch harness connector C116 terminal 3 and ground.
Continuity should exist.
Also check harness for short to ground and short to power.
OK or NG
OK >> GO TO 3.
NG >> Repair open circuit or short to ground or short to power in harness or connectors.

3. CHECK DIFFERENTIAL LOCK POSITION SWITCH
1. Remove differential lock position switch. Refer to "COMPONENTS".








2. Pull differential lock position switch and check continuity between differential lock position switch terminals.
OK or NG
OK >> GO TO 4.
NG >> Replace differential lock position switch.

4. CHECK HARNESS BETWEEN DIFFERENTIAL LOCK CONTROL UNIT AND DIFFERENTIAL LOCK POSITION SWITCH
1. Turn ignition switch OFF.
2. Disconnect differential lock control unit harness connector.





3. Check continuity between differential lock control unit harness connector M70 terminal 20 and differential lock position switch harness connector C116 terminal 3. Continuity should exist. Also check harness for short to ground and short to power.
OK or NG
OK >> GO TO 5.
NG >> Repair or replace damaged parts.

5. CHECK DIFFERENTIAL LOCK CONTROL UNIT
Check differential lock control unit input/output signal. Refer to "Differential Lock Control Unit Input/Output Signal Reference Values".
OK or NG
OK >> GO TO 6.
NG >> Check differential lock control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.

6. CHECK DTC
Perform the self-diagnosis, after driving the vehicle for a while.
OK or NG
OK >> Inspection End.
NG >> Replace differential lock control unit. Refer to "DIFFERENTIAL LOCK CONTROL UNIT".

COMPONENT INSPECTION
1. Turn ignition switch OFF.
2. Disconnect differential lock position switch harness connector.
3. Remove differential lock position switch. Refer to "COMPONENTS".








4. Pull differential lock position switch and check continuity between differential lock position switch terminals.
5. If NG, replace differential lock position switch.