CONSULT-II Function (All Mode AWD/4WD)
CONSULT-II Function (ALL MODE AWD/4WD)FUNCTION
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.
CONSULT-II SETTING PROCEDURE
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.
NOTE: For details, refer to the separate "CONSULT-II Operations Manual".
1. Turn ignition switch "OFF".
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector on vehicle.
3. Turn ignition switch "ON".
4. Touch "START (NISSAN BASED VHCL)".
5. Touch "ALL MODE AWD/4WD". If "ALL MODE AWD/4WD" is not indicated, go to GI-38, "CONSULT-II Data Link Connector (DLC) Circuit". CONSULT-II Checking System
6. Perform each diagnostic test mode according to each service procedure.