With Manufacturer's Scan Tool (CONSULT-II)

CONSULT-II INSPECTION PROCEDURE

"DOOR LOCK"

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.




1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.




3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)".




5. Touch "BCM".
If "BCM" is not indicated, refer to "CONSULT-II Data Link Connector (DLC) Circuit".




6. Touch DOOR LOCK.




7. Select diagnosis mode.
DATA MONITOR and ACTIVE TEST are available.