Control Module: Service and Repair
Removal and InstallationREMOVAL
1. Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
2. Remove the glove box assembly. Refer to LOWER INSTRUMENT PANEL RH AND GLOVE BOX.
3. Disconnect transfer control unit connectors.
4. Remove the transfer control unit.
INSTALLATION
Note the following, and install in the reverse order of removal. When installing the transfer control unit, tighten bolts to the specified torque.
Transfer control unit bolts: 5.1 Nm (0.52 kg-m, 45 inch lbs.)
^ After the installation, check 4WD shift indicator pattern. If NG adjust position between transfer assembly and transfer control unit. Refer to Precautions for Transfer Assembly and Transfer Control Unit Replacement.