Oil Pan, Engine
Oil PanInstall oil pan (upper) using the following steps.
Apply liquid gasket thoroughly as shown.
Use Genuine RTV Silicone Sealant or equivalent. Refer to "Recommended Chemical Products and Sealants".
CAUTION: Apply liquid gasket to outside of bolt hole for the hole shown by *.
Install new O-rings to oil pump and front cover side.
Tighten bolts in numerical order as shown.
M6 x 30 mm (1.18 inch No. 15, 16
M8 x 25 mm (0.98 inch No. 1, 3, 5, 7, 11, 13
M8 x 45 mm (1.77 inch) No. 2, 4, 6, 8, 10, 14
M8 x 123 mm (4.84 inch) No. 9, 12
Install rear plate cover.
Install oil strainer to upper oil pan (upper).
Install oil pan (lower).
Apply liquid gasket thoroughly as shown.
Use Genuine RTV Silicone Sealant or equivalent. Refer to "Recommended Chemical Products and Sealants".
Tighten oil pan (lower) bolts in numerical order as shown.
Install oil pan drain plug.
Installation of the remaining components is in the reverse order of removal.
Do not fill the engine oil for at least 30 minutes after oil pan is installed.