Initial Inspection and Diagnostic Overview

BASIC INSPECTION
1. CHECK BCM CONFIGURATION
Confirm BCM configuration for "DISPLAY STYLE" is set to:
^ "MODE 1" for vehicles without Navigation display screen.
^ "MODE 2" for vehicles with Navigation display screen.
Refer to BCS-13, "READ CONFIGURATION PROCEDURE". Programming and Relearning
OK or NG
OK >> GO TO 2.
NG >> Change BCM configuration for "DISPLAY STYLE" to "MODE1" or "MODE2".
2. CHECK ALL TIRE PRESSURES
Check all tire pressures.
OK or NG
OK >> GO TO 3.
NG >> Adjust tire pressure to specified value.
3. CHECK LOW TIRE PRESSURE WARNING LAMP ACTIVATION
1. Check low tire pressure warning lamp activation.
2. Does low tire pressure warning lamp activate for 1 second when ignition switch is turned "ON"?
YES >> GO TO 4.
NO >> Check fuse and combination meter.
4. CHECK CONNECTOR
1. Disconnect BCM harness connector.
2. Check terminals for damage or loose connection.
3. Reconnect harness connector.
OK or NG
OK >> GO TO 5.
NG >> Repair or replace damaged parts.
5. CHECK TRANSMITTER ACTIVATION TOOL
Check transmitter activation tool battery.
OK or NG
OK >> Carry out self-diagnosis.
NG >> Replace transmitter activation tool battery