A/T Does Not Shift: 3RD Gear->2ND Gear (Floor Shift Models)

A/T Does Not Shift: 3rd gear -> 2nd gear (Floor Shift Models)

SYMPTOM: When shifted from 3[3] to 2[2] position, does not downshift from 3rd to 2nd gears.

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
Perform self-diagnosis. Refer to "SELF-DIAGNOSTIC RESULT MODE". Reading Diagnostic Trouble Codes
Do the self-diagnosis results indicate PNP switch, ATF pressure switch 6?
YES >> Check the malfunctioning system.
NO >> GO TO 2.
2. CHECK A/T FLUID LEVEL





Check the A/T fluid level.
OK or NG
OK >> GO TO 3.
NG >> Refill ATF.
3. CHECK CONTROL CABLE





Check the control cable.
OK or NG
OK >> GO TO 4.
NG >> Adjust control cable.
4. CHECK A/T FLUID CONDITION





1. Remove oil pan.
2. Check A/T fluid condition.
OK or NG
OK >> GO TO 5.
NG >> GO TO 8.
5. DETECT MALFUNCTIONING ITEM
^ Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to "Symptom Chart" (Symptom No.16). Symptom Chart
OK or NG
OK >> GO TO 6.
NG >> Repair or replace damaged parts.
6. CHECK SYMPTOM
Check again. Cruise Test - Part 3
OK or NG
OK >> INSPECTION END
NG >> GO TO 7.
7. PERFORM TCM INSPECTION
1. Perform TCM input/output signals inspection. Refer to "TCM Input/Output Signal Reference Values". TCM Input/Output Signal Reference Values
2. If NG, recheck A/T assembly harness connector terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.
8. DETECT MALFUNCTIONING ITEM
^ Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to "Symptom Chart" (Symptom No.16). Symptom Chart
OK or NG
OK >> GO TO 6.
NG >> Repair or replace damaged parts.