Body Control Module: Service and Repair
BCMREMOVAL AND INSTALLATION
Removal
NOTE: If possible, before removing BCM, retrieve current BCM configuration to use for reference when configuring new BCM after installation. Refer to "Configuration". Programming and Relearning
1. Disconnect battery negative cable.
2. Remove lower knee bolster.
3. Remove screw and release BCM.
4. Disconnect connectors and then remove BCM.
Installation
Install in the reverse order of removal.
NOTE:
- When replacing BCM, it must be configured. Refer to "Configuration". Programming and Relearning
- When replacing BCM, perform initialization of NATS system and registration of all NATS ignition key IDs. Refer to BL-139, "NVIS(NISSAN Vehicle Immobilizer System-NATS)". Antitheft and Alarm Systems
- When replacing BCM, perform ID registration procedure of low tire pressure warning system. Refer to WT-15, "ID Registration Procedure". Testing and Inspection