CONSULT-II Basic Operation Procedure

CONSULT-II BASIC OPERATION PROCEDURE
1. Turn ignition switch OFF.





2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

3. Turn ignition switch ON.





4. Touch "START (NISSAN BASED VHCL)".





5. Touch "ABS" in the "SELECT SYSTEM" screen. If "ABS" is not indicated, go to GI-41, "CONSULT-II Data Link Connector (DLC) Circuit". Electrical Diagrams
6. Select the required diagnostic location from the "SELECT DIAG MODE" screen. For further information, see the CONSULT-II Operation Manual.