Active Test

ACTIVE TEST

CAUTION:
^ Do not perform active test while driving.
^ Make sure to completely bleed air from the brake system.
^ The ABS and brake warning lamps turn on during the active test.

Operation Procedure
1. Connect the CONSULT-II and CONSULT-II CONVERTER to the data link connector and start the engine.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

2. Touch "START (NISSAN BASED VHCL)" on the display screen.
3. Touch "ABS". If "ABS" is not indicated, go to GI-41, "CONSULT-II Data Link Connector (DLC) Circuit". Electrical Diagrams
4. Touch "ACTIVE TEST".





5. The test item selection screen is displayed.
6. Touch necessary test item.
7. With the "MAIN SIGNALS" display selected, touch "START".
8. The Active Test screen will be displayed, so conduct the following test.

Solenoid Valve Operation Chart:

NOTE:
^ If active test is performed with brake pedal depressed, pedal stroke may change. This is normal.
^ "TEST IS STOPPED" is displayed approximately 10 seconds after operation starts.
^ After "TEST IS STOPPED" is displayed, to perform test again, repeat Step 6.

ABS MOTOR





Touch "ON" and "OFF" on the screen. Check that ABS motor relay operates as shown in table.





NOTE:
^ If active test is performed with brake pedal depressed, pedal stroke may change. This is normal.
^ "TEST IS STOPPED" is displayed approximately 10 seconds after operation starts.