Removal and Installation

[1][2]G SENSOR

Removal and Installation
REMOVAL
1. Remove center console.





2. Remove yaw rate/side/decel G sensor attaching nuts as shown.
^ The location of the sensor is the same for all models.

CAUTION:
^ Do not use power tools to remove or install yaw rate/side/decel G sensor.
^ Do not drop or strike the yaw rate/side/decel G sensor.

3. Disconnect harness connector and remove the yaw rate/side/decel G sensor.

INSTALLATION
Installation is in the reverse order of removal.

NOTE: After performing the above work, calibrate the decel [1][2]G sensor settings of the yaw rate/side/decel G sensor.