CONSULT-II Basic Operation Procedure

CONSULT-II BASIC OPERATION PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.




1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
3. Turn ignition switch ON.




4. Touch "START (NISSAN BASED VHCL)".




5. Touch "BCM".
If "BCM" is not indicated, go to GI-41, "CONSULT-II Data Link Connector (DLC) Circuit". Schematic




6. Touch "REAR DEFOGGER".




7. Select diagnosis mode,"DATA MONITOR" or "ACTIVE TEST".