Removal and Replacement

FRONT DOOR GLASS AND REGULATOR

Front Door Glass

REMOVAL
1. Remove the front door finisher. Refer to "FRONT DOOR".
2. If equipped, temporarily reconnect the power window switch.

7. While holding the door window, raise it at the rear and pull the glass out of the sash toward the outside of the door.

INSTALLATION
Installation is in the reverse order of removal.

Glass bolts : 6.1 N.m (0.62 kg-m, 54 in-lb)

- Check the glass for proper fit. Refer to "FITTING INSPECTION".
- On the drivers door, reset the motor. Refer to "SETTING AFTER INSTALLATION". Programming and Relearning

FITTING INSPECTION
- Check that the glass fits securely into the glass run groove.
- Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)] and check that the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator bolts, guide rail bolts, and glass and guide rail bolts to adjust the glass position.

Regulator and motor or crank assembly bolts : 5.7 N.m (0.58 kg-m, 50 in-lb)
Glass bolts : 6.1 N.m (0.62 kg-m, 54 in-lb)

Front Door Glass Regulator

REMOVAL
1. Remove the front door finisher. Refer to "FRONT DOOR".
2. If equipped, temporarily reconnect the power window switch.

3. For power windows, operate the power window main switch to raise/lower the door window until the glass bolts can be seen.
4. For manual windows, temporarily reinstall the window crank handle and lower the window until the glass bolts can be seen.
5. Remove the inside seal.
6. Remove the glass bolts.
7. Raise the front door glass and hold it in place with suitable tool.
8. If equipped, disconnect the harness connector from the regulator assembly.

9. Remove the bolts and the regulator assembly.