Sunroof / Moonroof: Adjustments

SUNROOF




Fitting Adjustment

GAP ADJUSTMENT

NOTE: If any gap or height difference between glass lid assembly and roof panel is found check glass lid assembly fit and adjust as follows:

1. Open sunshade assembly.
2. Loosen glass lid assembly securing screws (2 each on left and right sides) then tilt down.
3. Manually adjust glass lid assembly from outside of vehicle so it resembles "A-A" as shown in the figure.
4. After adjusting glass lid assembly tilt up and tighten screws.
5. Tilt glass lid assembly up and down several times to check that it moves smoothly.

HEIGHT DIFFERENCE ADJUSTMENT
If an excessive height difference between glass lid assembly and roof panel is found, adjust in the following manner:
1. Remove headlining. Refer to "HEADLINING".
2. Loosen sunroof frame assembly nuts and sunroof bracket bolts.
3. Add shims until gap is within specification "A-A".

NOTE: Temporarily snug nuts and bolts to prevent movement between each adjustment.

4. Tilt glass lid assembly up and down several times to check that it moves and seals properly.
5. Tighten sunroof frame assembly nuts and sunroof bracket bolts.

NOTE: First tighten left front then right rear sunroof frame assembly to prevent uneven torque while tightening remaining sunroof bracket bolts.

6. Install headlining. Refer to "HEADLINING".