Tail Lamp: Description and Operation

PARKING, LICENSE PLATE AND TAIL LAMPS

Parking, License Plate And Tail Lamps Schematic:

PARKING, LICENSE PLATE AND TAIL LAMPS Schematic

System Description
Control of the parking, license plate, and tail lamp operation is dependent upon the position of the lighting switch (combination switch). When the lighting switch is placed in the 1ST position, the BCM (body control module) receives input signal requesting the parking, license plate, side marker and tail lamps to illuminate. This input signal is communicated to the IPDM E/R (intelligent power distribution module engine room) across the CAN communication lines. The CPU (central processing unit) of the IPDM E/R controls the tail lamp relay coil. This relay, when energized, directs power to the parking, license plate and tail lamps, which then illuminate.

Power is supplied at all times
- to ignition relay, located in the IPDM E/R,
- to tail lamp relay, located in the IPDM E/R,
- through 20 A fuse (No. 53, located in the IPDM E/R)
- to CPU of the IPDM E/R, and
- through 50 A fusible link (letter f, located in the fuse and fusible link box)
- to BCM terminal 70.

With the ignition switch in the ON or START position, power is supplied
- to ignition relay, located in the IPDM E/R, and
- through 10 A fuse (No. 59, located in the fuse and relay box)
- to BCM terminal 38.

Ground is supplied
- to BCM terminal 67
- through grounds M57, M61 and M79, and
- to IPDM E/R terminals 38 and 59
- through grounds E9, E15 and E24.

OPERATION BY LIGHTING SWITCH
With the lighting switch in the 1ST or 2ND position (or if the auto light system is activated), the BCM receives input signal requesting the parking, license plate, side marker and tail lamps to illuminate. This input signal is communicated to the IPDM E/R across the CAN communication lines. The CPU of the IPDM E/R controls the tail lamp relay coil, which when energized, directs power
- through 10 A fuse (No. 37, located in the IPDM E/R)
- through IPDM E/R terminal 57
- to front combination lamp LH and RH terminal 6
- to license plate lamps terminal 1 and
- to rear combination lamp LH and RH terminal 2.

Ground is supplied
- to front combination lamp LH and RH terminal 4, and
- to license plate lamps terminal 2
- through grounds E9, E15 and E24,
- to rear combination lamp LH terminal 3
- through grounds B7 and B19, and
- to rear combination lamp RH terminal 3
- through grounds B117 and B132.

With power and ground supplied, the parking, license plate and tail lamps illuminate.

COMBINATION SWITCH READING FUNCTION
Refer to "COMBINATION SWITCH READING FUNCTION" in "Body Control System".

EXTERIOR LAMP BATTERY SAVER CONTROL
Refer to "BATTERY SAVER CONTROL".

CAN Communication System Description
Refer to LAN-4, "Information bus". Information Bus