Diagnostic Procedure 2

Trouble Diagnosis With CONSULT-II

DIAGNOSTIC PROCEDURE 2
Refer to GI-38, "CONSULT-II Start Procedure". With Manufacturer's Scan Tool




Diagnostic code is displayed on "SELF-DIAG [CURRENT]".




If no malfunction is detected on "SELF-DIAG [CURRENT]", but malfunction is detected in "SRS Operation Check", the following cases may exist:
- "SELF-DIAG [PAST]" memory might not be erased.
- The SRS system malfunctions intermittently.

Refer to "DIAGNOSTIC PROCEDURE 4".

CONSULT-II Diagnostic Code Chart (Part 1):

CONSULT-II Diagnostic Code Chart (Part 2):

CONSULT-II Diagnostic Code Chart (Part 3):

CONSULT-II Diagnostic Code Chart (Part 4):

CONSULT-II Diagnostic Code Chart (Part 5):

CONSULT-II Diagnostic Code Chart (Part 6):

CONSULT-II Diagnostic Code Chart

NOTE: Follow the procedures in numerical order when repairing malfunctioning parts. Confirm whether malfunction is eliminated using air bag warning lamp or CONSULT-II each time repair is finished. If malfunction is still observed, proceed to the next step. When malfunction is eliminated, further repair work is not required.