Diagnostic Procedure 3
DIAGNOSTIC PROCEDURE 3Final Check of SRS Using CONSULT-II-Diagnosis Mode
Refer to GI-38, "CONSULT-II Start Procedure". With Manufacturer's Scan Tool
1. If no DTC is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 2.
If any DTC is detected on "SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Go to SRS-23, "DIAGNOSTIC PROCEDURE 2". Diagnostic Procedure 2
2. Touch "ERASE".
NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").
If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.
3. Touch "BACK" key of CONSULT-II to "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".
4. Check that no malfunction is detected on "SELF-DIAG [PAST]".
5. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.
6. Turn ignition switch OFF then turn off and disconnect CONSULT-II.
7. Go to SRS-21, "DIAGNOSTIC PROCEDURE 1". [1][2]Component Tests and General Diagnostics