Removal And Installation

INSTRUMENT PANEL ASSEMBLY

Removal and Installation

Exploded View IP10 (Part 1):

Exploded View IP10 (Part 2):

INSTRUMENT PANEL

Removal
1. Remove the center console.
2. Remove instrument lower cover LH.
3. Remove the steering column.
4. Remove the combination meter.
5. Remove audio unit.
6. Remove display unit.
7. Remove lower knee protector.
8. Remove defroster grille and disconnect the optical sensor harness.
9. Remove side ventilator assembly LH.
10. Remove the LH assist grip and windshield garnish.
11. Remove side ventilator assembly RH.
12. Remove the RH assist grip and windshield garnish.
13. Remove the passenger air bag module.
14. Remove instrument panel.
15. Disconnect remaining instrument panel assembly electrical connectors.

Installation
Installation is in the reverse order of removal.




CLUSTER LID C

Removal
1. Disconnect battery negative terminal.
2. Pull cluster lid C towards rear of vehicle to release clips.
3. Disconnect cluster lid C electrical connectors.

Installation
Installation is in the reverse order of removal.




CLUSTER LID D

Removal
1. Remove A/T finisher.
2. Remove glove box. Refer to "LOWER INSTRUMENT PANEL RH AND GLOVE BOX".
3. Remove cluster lid C.
4. Remove cluster lid D by pulling toward the rear of the vehicle to release the clips.
5. Disconnect cluster lid D electrical connectors.

Installation
Installation is in the reverse order of removal.

LOWER INSTRUMENT PANEL LH

Removal




1. Remove instrument lower cover LH, using power tool.
2. Pull to disconnect lower instrument panel LH clips.
3. Disconnect lower instrument panel LH electrical connectors.

Installation
Installation is in the reverse order of removal.

COMBINATION METER

Removal
1. Disconnect battery negative terminal.
2. Remove the lower instrument panel LH.
3. Remove steering column cover upper and steering column cover lower.




4. Remove the combination meter cover.
5. Remove cluster lid A.
6. Disconnect cluster lid A electrical connectors.
7. Remove combination meter screws, using power tool.
8. Disconnect combination meter electrical connectors.

Installation
Installation is in the reverse order of removal.

A/T FINISHER

Removal
1. Remove the shift knob.




2. Remove the storage compartment mask.
3. Pull up to release clips and remove the A/T finisher.
4. Disconnect A/T finisher electrical connector.

Installation
Installation is in the reverse order of removal.

LOWER INSTRUMENT PANEL RH AND GLOVE BOX

Removal




1. Remove instrument lower cover RH.
2. Remove glove box assembly screws using power tool.
3. Disconnect glove box lamp.
4. Remove the lower instrument panel RH and glove box.

Installation
Installation is in the reverse order of removal.

Exploded View IP14:

CENTER CONSOLE

Removal
1. Remove control device.
2. Remove glove box. Refer to "LOWER INSTRUMENT PANEL RH AND GLOVE BOX".
3. Remove center console lower cover RH and center console lower cover LH.
4. Remove screws from center console.
5. Disconnect center console electrical connector.
6. Move front seats forward and remove the center console assembly.

Installation
Installation is in the reverse order of removal.