Diagnostic Procedure 5
DIAGNOSTIC PROCEDURE 5Check SRS Intermittent Malfunction Using CONSULT-II-Diagnosis Mode
Refer to GI-38, "CONSULT-II Start Procedure". With Manufacturer's Scan Tool
1. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 4.
If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".
2. Touch "TROUBLE DIAG RECORD".
NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.
3. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
4. Touch "PRINT".
5. Compare diagnostic codes to "CONSULT-II Diagnostic Code Chart". Air Bag System
6. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears.
7. Turn ignition switch OFF, then turn off and disconnect CONSULT-II, and both battery cables.
8. Repair the system as outlined by the "Repair order" in "Intermittent Malfunction Diagnostic Code Chart", that corresponds to the self-diagnostic result. For replacement procedure of component parts, refer to the Removal and Installation procedure for the appropriate component.
9. Go to SRS-27, "DIAGNOSTIC PROCEDURE 3", for final checking. Diagnostic Procedure 3