HDC/HSA/VDC/TCS/ABS

WHEEL SENSORS

Removal and Installation

Exploded View BRC-127:

REMOVAL
1. Remove wheel sensor bolt.
^ When removing the front wheel sensor, first remove the disc rotor to gain access to the front wheel sensor bolt.
2. Pull out the sensor, being careful to turn it as little as possible.

CAUTION:
^ Be careful not to damage sensor edge and sensor rotor teeth.
^ Do not pull on the sensor harness.

3. Disconnect wheel sensor harness electrical connector, then remove harness from mounts.

INSTALLATION
^ Before installing wheel sensors,
- Inspect wheel sensor assembly and replace if damaged.
- Clean wheel sensor hole and mating surface with brake cleaner and a lint-free shop rag. Be careful that dirt and debris do not enter the axle.
- Install a new wheel sensor O-ring, then apply a coat of suitable grease to the O-ring and sensor hole.
^ Installation is in the reverse order of removal.