Closed Throttle Position and Wide Open Throttle Position Circuit
CLOSED THROTTLE POSITION AND WIDE OPEN THROTTLE POSITION CIRCUITCONSULT-III Reference Value in Data Monitor Mode:
Diagnosis Procedure
1. CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to TM-33, "CONSULT-III Function (TRANSMISSION)". Scan Tool Testing and Procedures
Is a malfunction in the CAN communication indicated in the results?
YES >> Check CAN communication line. Refer to TM-39. U1000
NO >> GO TO 2.
2. CHECK THROTTLE POSITION SIGNAL CIRCUIT
With CONSULT-III
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Depress accelerator pedal and read out the value of "CLSD THL POS" and "W/O THL POS".
OK or NG
OK >> INSPECTION END
NG >> Check the following items. If NG, repair or replace damaged parts.
^ Perform the self-diagnosis for "ENGINE" with CONSULT-III.
^ Open circuit or short to ground or short to power in harness or connectors.
^ Pin terminals for damage or loose connection with harness connector.