Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor (PHASE)

REMOVAL
1. Remove engine room cover using power tool.
2. Remove air duct and resonator assembly.
3. Disconnect camshaft position sensor connector.




4. Remove camshaft position sensor (2) from Intake valve control solenoid valve cover (LH) (1).

INSTALLATION
Installation is in the reverse order of removal.

CAUTION: Replace the O-ring (3) of the camshaft position censor with a new one, then lubricate O-ring with engine oil before installing.

Camshaft position sensor bolt: 9.6 N.m (0.98 kg-m, 85 in-lb)