Removal and Installation

Removal and Installation

DLN-178 Components:

REMOVAL
1. Drain the differential gear oil.
2. Remove the drive shafts from the front final drive assembly.
3. Remove the front cross member.
4. Remove the front propeller shaft from the front final drive assembly.
5. Disconnect the vent hose from the front final drive assembly.
6. Support the front final drive assembly using a suitable jack.





7. Remove the front final drive assembly bolts, then remove the front final drive assembly

CAUTION: Support the front final drive assembly while removing using a suitable jack.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
^ Make sure there are no pinched or restricted areas on the breather hose caused by folding or bending when installing it.
^ Fill the front final drive assembly with differential gear oil after installation. Refer to DLN-173. Changing Differential Gear Oil