With Intelligent Key System

PINCH STRIP SYSTEM


Diagnosis Procedure

1.PINCH STRIP SIGNAL INSPECTION
1. Turn ignition switch OFF.





2. While operating the pinch strip, check voltage between back door control unit connector B55 terminals 19, 20 and ground.





Is the inspection result normal?
YES - Switch is OK.
NO - GO TO 2
2.PINCH STRIP CIRCUIT INSPECTION
1. Disconnect pinch strip and back door control unit connector.





2. Check continuity between back door control unit connector (A) B55 terminals 5, 19 (RH) or 5, 20 (LH) and pinch strip connector (B) D715 (RH), D517 (LH) terminals 1, 2.






3. Check continuity between pinch strip connector (B) D715 (RH), D517 (LH) terminals 1, 2 and ground.






Is the inspection result normal?
YES - Replace the pinch strip.
NO - Repair the harness between the pinch strip and the back door control unit.