Removal And Installation

CRASH ZONE SENSOR


Removal and Installation


REMOVAL

CAUTION:
- Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not disassemble crash zone sensor.
1. Disconnect the negative and positive battery cables, then wait at least 3 minutes.
2. Remove front grille. Refer to Service and Repair.





3. Disconnect the crash zone sensor harness connector.
4. Remove crash zone sensor nuts.

INSTALLATION
Installation is in the reverse order of removal.
- After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to On Board Diagnostic (OBD) System.