Alarm System Transponder: Service and Repair

NATS ANTENNA AMP.


Removal and Installation


NOTE:
- If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and "SELF-DIAG RESULTS" on CONSULT-III screen will show "LOCK MODE" or "CHAIN OF IMMU-KEY".
- Initialization is not necessary when only the NATS antenna amp. is replaced with a new one.

REMOVAL
1. Disconnect the battery negative terminal. Refer to Removal and Replacement.
2. Remove cluster lid A. Refer to Exploded View.





3. Remove the bolt (A), disconnect the electrical connector (1) and remove the NATS antenna amp (2).

INSTALLATION
Installation is in the reverse order of removal.