A/T Does Not Shift 2Nd Gear To 1St Gear

SYSTEM SYMPTOM


A/T Does Not Shift: 2nd gear to 1st gear


SYMPTOM:
When shifted from 22 to 11 position, does not downshift from 2nd to 1st gears.

DIAGNOSTIC PROCEDURE
1.CHECK SELF-DIAGNOSIS RESULTS
Perform self-diagnosis. Refer to CONSULT-III Function (Transmission).
Is any malfunction detected by self-diagnostic results?
YES - Check the malfunctioning system. Refer to CONSULT-III Function (Transmission).
NO - GO TO 2.
2.CHECK 1ST POSITION SWITCH CIRCUIT
With CONSULT-III
1. Turn ignition switch "ON".
2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Read out "1 POSITION SW" switch moving selector lever to each position.





Without CONSULT-III
1. Turn ignition switch "ON". (Do not start engine)
2. Check voltage between A/T device harness connector terminal and ground.





OK or NG
OK - GO TO 3.
NG - Repair or replace damaged parts.
3.CHECK A/T FLUID LEVEL
Check the A/T fluid level. Refer to Checking The A/T Fluid (ATF).
OK or NG
OK - GO TO 4.
NG - Refill ATF.
4.CHECK CONTROL CABLE
Check the control cable.
- Refer to Procedures.
OK or NG
OK - GO TO 5.
NG - Adjust control cable. Refer to Adjustments.
5.CHECK A/T FLUID CONDITION
1. Remove oil pan. Refer to Service and Repair.
2. Check A/T fluid condition. Refer to Checking The A/T Fluid (ATF).
OK or NG
OK - GO TO 6.
NG - GO TO 9.
6.DETECT MALFUNCTIONING ITEM
- Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to Symptom Chart (Symptom No.17).
OK or NG
OK - GO TO 7.
NG - Repair or replace damaged parts.
7.CHECK SYMPTOM
Check again. Refer to Cruise Test - Part 3.
OK or NG
OK - INSPECTION END
NG - GO TO 8.
8.PERFORM TCM INSPECTION
1. Perform TCM input/output signals inspection. Refer to Pinout Values and Diagnostic Parameters.
2. If NG, recheck A/T assembly harness connector terminals for damage or loose connection with harness connector.
OK or NG
OK - INSPECTION END
NG - Repair or replace damaged parts.
9.DETECT MALFUNCTIONING ITEM
- Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to Symptom Chart (Symptom No.17).
OK or NG
OK - GO TO 7.
NG - Repair or replace damaged parts.