Air Breather Hose

AIR BREATHER HOSE


Removal and Installation


REMOVAL and INSTALLATION
2WD











CAUTION:
- Install air breather hose with paint mark at upper side.
- When installing the air breather hose, do not crush or block by folding or bending the hose.
- When inserting the hose to the transmission tube, be sure to insert it fully until its end reaches the tube bend portion.
- Make sure clip is securely installed to bracket.

REMOVAL
4WD











INSTALLATION

CAUTION:
Make sure there are no pinched or restricted areas on each air breather hose caused by folding or bending when installing it.





1. Install each air breather hose into the breather tube (4). Set each air breather hose with paint mark facing upward.
- A/T breather hose (1)
- Transfer breather hose (2)
- Actuator/transfer motor breather hose (3)
- Paint marks (A)





2. Install actuator/transfer motor air breather hose (1) and transfer air breather hose (2) on clip (A) with the paint mark (B) facing upward.
- Arrow indicates:Front





3. Install clip (B) on actuator/transfer motor air breather hose (1) and transfer air breather hose (2) with the paint mark (A) matched.
- Arrow indicates:Front





4. Install actuator/transfer motor air breather hose (1) and transfer air breather hose (2) on clip (B) and clip (C) with the paint mark
(A) and (D) facing upward.
- Arrow indicates:Front





5. Install the actuator air breather hose into the actuator (case connector) until the hose end reaches the base of the tube. Set actuator air breather hose with paint mark facing leftward.





6. Install clip (B) on transfer motor air breather hose (2) and transfer air breather hose (1) with the paint mark (A) matched.
- Arrow indicates:Front





7. Install the transfer air breather hose into the breather tube
(transfer, metal connector) until the hose end reaches the base of the tube. Set transfer air breather hose with paint mark facing upwards.





8. Install the transfer motor air breather hose into the transfer motor (case connector) until the hose end reaches the end of the curved section. Set transfer motor air breather hose with paint mark facing leftward.