Without ADP

OUTSIDE MIRROR


GLASS MIRROR : Disassembly and Assembly


CAUTION:
Never damage the mirror bodies.

DISASSEMBLY





1. Place the glass mirror upward.
2. Put a strip of protective tape (A) on the housing.
3. Insert flat-bladed screwdriver (B) into the recess at lower side between glass mirror (1) and actuator (2), and push up pawls to remove glass mirror lower side.

NOTE:
Insert a small slotted screwdriver into recess, and push up while rotating (twist) to make work easier.
4. Insert flat-bladed screwdriver at RH/LH side between glass mirror and actuator, and push up pawls to remove glass mirror RH/LH side.

NOTE:
Insert flat-bladed screwdriver into recesses, and push up while rotating (twist) to make work easier.
5. Remove two terminals of mirror heater attachment. (With heater mirror model)





6. Pull glass mirror as shown in the figure in order to disengage both upper pawls, and then remove glass mirror.






ASSEMBLY
Install in the reverse order of removal.

CAUTION:
After installation, visually check that pawls are securely engaged.