Disassembly and Assembly

REAR SEAT


Disassembly and Assembly


SEATBACK

Disassembly
1. Remove the armrest. (RH seat only)





- Remove the armrest outer cover.

Broken Triangle : Pawl






- Remove the armrest mounting bolts (A), and then slide the armrest to toward the arrow direction.
2. Separate the seatback assembly and seat cushion assembly.





- Disconnect the seat cushion heater unit harness connectors
(A) and remove the harness clamps. (with heater seat model only)





- Remove the seat cushion link cover.





- Remove the mounting bolt (A), and then separate the seatback assembly and seat cushion assembly.





3. Remove the mounting screw (A), and then remove the reclining device outer cover.





4. Remove the mounting screws (A), and then remove the reclining device inner cover (outside). (LH seat)
5. Remove the seatback trim and pad.





- Remove the clips, and then pull out the seatback board.

Broken Circle :Clip

- Remove the seatback trim fixing hog rings and retainer.





- Remove the headrest holder.

CAUTION:
Before installing headrest holder check its orientation.
(front/rear and right/left)
- Remove the seatback trim and pad from seatback frame.
- Remove the hog rings to separate the seatback trim and seatback pad.
6. Remove the seatback silencer.





7. Remove the screws (A), and then remove the reclining device inner cover (outside). (RH seat)





8. Remove the screw (A), and then remove the reclining device inner cover (inside).





9. Remove the mounting bolts (A), and then remove the seatback frame from reclining device assembly.





10. Remove the mounting nuts (A), and then remove the dynamic dumper. (With top road sunroof model only)

Assembly
Assemble in the reverse order of disassembly.

CAUTION:
Install the hog rings of seatback trim in position, and then securely connect the trim or trim cord with the seatback frame.

SEAT CUSHION

Disassembly
1. Remove the armrest. (RH seat only)





- Remove the pawl, and then pull out armrest outer cover.

Broken Triangle : Pawl






- Remove the mounting bolts (A), and then slide the armrest to outside.
2. Separate the seatback assembly and seat cushion assembly.





- Disconnect the seat cushion heater unit harness connectors
(A) and remove the harness clamps. (with heater seat model only)





- Remove the seat cushion link cover.





- Remove the mounting bolt (A), and then separate the seatback assembly and seat cushion assembly.
3. Remove the seat cushion trim.
Remove the seat cushion trim fixing retainers and hog rings, and then remove the seat cushion trim from seat cushion pad and frame.

Assembly
Assemble in the reverse order of disassembly.

CAUTION:
Install the hog rings of seat cushion trim in position, and then securely connect the trim or trim cord with the seat cushion pad wire.