Removal and Installation

REAR SEAT


Removal and Installation


REMOVAL

CAUTION:
When removing and installing, use shop cloths to protect parts from damage.
1. Remove the seat mounting bolts and nuts.
- Pull up the luggage floor finisher front (1).





- Remove the seat mounting bolt (A) and nut (B).
2. Disconnect the rear seat harness connector (A) and heater unit harness connector (B). (Power return seat and heater seat model only)





a. LH side b. RH side





3. Remove the reclining cover.





4. Remove the seatback control cable (1) from reclining device assembly and seat mounting bolt (A).
5. Remove the seat cushion hinge cover.





6. Remove the rear seat mounting bolts (A).





7. Pull up the seat cushion and remove the seat mounting bolt (A).
8. Remove the rear seat assembly from back door.

INSTALLATION

NOTE:
Tighten rear seat mounting bolts and nuts following the numerical order shown in the figure.





1. Install the rear seat mounting bolt on behind the seatback (out side) and nut on behind the seatback (inside).
2. Install the rear seat mounting bolt on the seat cushion out side.
3. Connect the rear seat harness connector and heater harness connector. (Power return seat and heater seat only)





4. Install the rear seat mounting bolt on the reclining device extension bracket.





5. Install the rear seat mounting bolt and on the seat cushion hinge.
6. Connect the seatback control cable.
7. Install the seat cushion hinge cover.
8. Install the reclining cover.

CAUTION:
- When removing and installing, use shop cloths to protect parts from damage.
- When removing and installing, 2 workers are required so as to prevent it from dropping.
- Before installation, check that the rear seat harness and seatback control cable is not pressed by seat frame.