Removal And Installation

BACK DOOR LOCK


TOUCH SENSOR : Removal and Installation


CAUTION:
Take care not to bend touch sensor.

REMOVAL
1. Remove back door finisher inner. Removal And Installation.
2. Disconnect touch sensor connector.





3. Remove clips and TORX bolts touch sensor (1).

CAUTION:
Remove the TORX bolts (black arrow) and clips (white arrow) of touch sensor referring to figure.
4. Pull harness of touch sensor out of back door and remove touch sensor.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Install the clips and TORX bolts of touch sensor in the reverse order of removal.
- Never place back door side seal between touch sensor.
- Check back door open/close operation after installation.