Diagnosis Procedure

AWD LOCK INDICATOR LAMP


Description

The following is the indications of indicator lamp after the engine start.

AWD LOCK INDICATOR LAMP










AWD LOCK INDICATOR LAMP


Diagnosis Procedure

1.CHECK AWD WARNING LAMP
Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.
Does AWD warning lamp turn ON?
YES - Proceed to Diagnosis Procedure.
NO - GO TO 2.
2.CHECK AWD LOCK SWITCH
Perform the trouble diagnosis for AWD lock switch. Diagnosis Procedure.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace the error-detected parts.
3.CHECK AWD LOCK INDICATOR LAMP SIGNAL
With CONSULT-III
1. Start the engine.

CAUTION:
Stop the vehicle.
2. Change AWD lock switch to "LOCK" from "AUTO".
3. Check "4WD MODE MON" of CONSULT-III "DATA MONITOR" for "ALL MODE AWD/4WD".
Does the item on "DATA MONITOR" indicate "LOCK"?
YES - GO TO 4.
NO - Replace AWD control unit. Exploded View.
4.CHECK COMBINATION METER POWER SUPPLY CIRCUIT
Perform the trouble diagnosis for combination meter power supply circuit. Combination Meter IPDM E/R (Intelligent Power Distribution Module Engine Room).
Is the inspection result normal?
YES - INSPECTION END
NO - Repair or replace the error-detected parts.