Removal and Installation

BACK DOOR


BACK DOOR ASSEMBLY : Removal and Installation


CAUTION:
Perform work with 2 workers, because of its heavy weight.

NOTE:
The back door harness constitute the back door assembly.

REMOVAL
1. Remove back door finisher inner, back door hinge cover, back door plate. Removal And Installation.
2. Remove grommet, and then disconnect connector (1), and washer tube (2).





3. Pull harness and washer tube out of back door.
4. Support back door lock with the proper material to prevent it from falling.





5. Remove mounting bolts of power back door drive assembly (1).
(back door side)
6. Remove back door stay on back door side. Removal and Installation.
7. Remove back door hinge mounting bolts on back door and remove back door assembly.
8. Remove the following parts after removing back door assembly.
- Bumper rubber
- Stud ball
- Back door lock assembly: Removal And Installation.
- Touch sensor: Removal And Installation.
- Patch: Exploded View.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Check back door open/close, lock/unlock operation after installation.
- After installation, perform fitting adjustment. Adjustments.