Flushing

ENGINE COOLANT


Flushing

1. Install reservoir tank if removed and radiator drain plug.

CAUTION:
Be sure to clean drain plug and install with new O-ring.

Tightening torque : Exploded View.

If water drain plugs on cylinder block are removed, close and tighten them. Disassembly And Assembly.
2. Remove air duct assembly and air cleaner cases (upper and lower) assembly. Exploded View.





3. Disconnect heater hose (1) at the position (Black Arrow Indicates) in the figure.

Arrow Indicates : Vehicle front

4. Fill radiator and reservoir tank with water and reinstall radiator cap.

CAUTION:
Never adhere the water to electronic equipments. (alternator etc.)
- When water overflows disconnected heater hose, connect heater hose, and continue filling the water.
5. Run the engine and warm it up to normal operating temperature.
6. Rev the engine two or three times under no-load.
7. Stop the engine and wait until it cools down.
8. Drain water from the system. Draining.
9. Repeat steps 1 through 8 until clear water begins to drain from radiator.